Anritsu/MG3633A/0.01-2700MHz合成信号发生器

• Anritsu/MG3633A/0.01-2700MHz合成信号发生器
• 欲购买或租赁Anritsu/MG3633A/0.01-2700MHz合成信号发生器？请在线咨询或拔打24小时电话：13715327187

详细资料：

    MG3633A具有优越的频率解析度，频率切换速度，信号纯度，和高输出电平，另外还有振幅，频率和相位调制功能。还有载波频率，输出电平，和调制频率扫描功能，所以精确扫描可被多种设备检测。l MG3633A具有一个频率存储区可存储1000个载波频率和一个功能存储区可存储100个面板设置。其最大输出电平为+17dBm，可与多种信号源连接使用.
技术指标

Carrier frequency	Range	10 kHz to 2700MHz
	Resolution	0.01Hz
	Accuracy	Same as that of the reference oscillator
	Internal reference oscillator*^1	Frequency:10MHz Start-up characteristics:After 30 minutes of operation:≤1*10^-7/day, after 60 minutes of operation: ≤5*10^-8/day, Aging rate :After 24 hours of operationL≤2*10^-8/day, Temperature characteristics: ±5*10^-8/day (0° to 50℃)
	External reference signal input	10MHz,TTL Level,BNC connector on rear panel
	Reference signal output	10MHz,TTL Level,BNC connector on rear panel
	Switching time	≤10ms (time form last command until frequencyhas stabilized to within ±500Hz of set frequency,during remote operation)
Output	Range	-143 to +23dB
	Units	dBm,dBμV,V,mV,μV,(Terminated and open voltages are selectable for dBμV,V,mV,or μV)
	Resloution	0.1dB
	Frequency response	±0.5dB referred to 0 dBm (<1280MHz),±1dBreferred to 0 dBm(≥1280MHz)
	Accuracy	Output level\ Frequency	10kHz to <1280MHz	≥1280MHz
		+1701 to +23dBm	-	-
		+15.1 to +17dBm	±1dB	-
		-122.9 to +15dBm	±1dB	±2dB
		-132.9 to -123 dBm	±3dB	±4dB
		-143 to -133dBm	-	-
	Impedance	50Ω,N-type connector VSWR:≤1.5(<1280MHz,≤-3dBm)≤1.8(≥1280MHz≤-3dBm)
	Switching time	Time form last command until output levelis stabillzed ,during remote operation:≤25ms(at LEVEL NORMAL mode) ≤5ms (at LEVEL CONTINUOUS mode)
	Interference radiation	≤1μV(Value is voltage terminated with 50Ωload ,measured 25 mm form oront panel with a two-turn 25mm diameter loopantenna )Except sweep mode
Signal purity	Spurious	At+7dBm CW mode:(fc: carrier frequency)
		Harmonics(2nd,3rd):≤-30dBc(at ≥100kHz) Sub-harmonics(fc/2,3fc/2,5fc/2):None(at <1280MHz)≤-30dBc(at ≥1280MHz) Non-harmonics: ≤-80dBc(fc <640MHz;≥10kHz offset) ≤-74dBc(640MHz≤fc<1280MHz≥10kHz forrst ≤-68dBc(fc ≥1280MHz,≥10kHz offset)
	SSB phase noise	At+7dBm,CW mode,0° to 35℃
		Offset frequency	1kHz	20 to 300kHz
		0.01 to <40 MHz	-116dBc/Hz	-140dBc/Hz
		40 to <300MHz	-119dBc/Hz	-145dBc/Hz
		300 to <600MHz	-113dBc/Hz	-143dBc/Hz
		600 to <1100MHz	-107dBc/Hz	-140dBc/Hz
		1.1 to <2.4GHz	-101dBc/Hz	-132dBc/Hz
		2.4 to <237GHz	-97dBc/Hz	-120dBc/Hz
		Floor noise:≤145 dBc/Hz(40 to <110MHz)
	Residual AM	≤0.02% rms at ≥150kHz(demodulation band:300Hzto 3kHz)
	Residual FM	≤0.8Hz rms at <1280MHz(demdulation band:300Hz to 3kHz) ≤4Hz rms at <1280MHz(demdulation band :300Hz to 3kHz)
Ampli- tude modul- ation	Range	0 to 100%
	Resolution	01%
	Internal modulation frequency	Fixed frequency:400Hz,1kHz Variable frequecny:0.1Hz to 50 kHz ,0.1Hz resolution Frequency accuracy:100 ppm
	Accuracy	±(5% of indicated value+2%)[at ≥250kHz ,≤+7dBm,0 t 90% and internal 1kHz
		At ≤±7dBm±1dBbandwith
	Lower modulation frequency limit	20Hz(EXT AC mode),DC(EXT DC mode)
	Upper modulation frequency limit	Carrier frequecny\ Modulation factor	0 to 30%	30.1 to 80%
		0.25 MHz ≤fc<0.5MHz	5kHz	5kHz
		0.5 MHz ≤fc<80MHz	20kHz	10kHz
		80MHz≤fc	50kHz	20kHz
	External modulation	Input level:Approx.2 Vp-p 600Ω Input Impedance:Nominal 600Ω
	Depth	≤1%(at≥1MHz≤+7dBm internal 1kHz 30%z) ≤3%(at≥1MHz≤+7dBm internal 1kHz 80%) ≤ 3%(at 250kHz≤fc<1MHz ≤+7dBm internal 1kHz 30%) ≤10%( at 250kHz≤fc<1MHz ≤+7dBm internal 1kHz 100%)
	Incidental FM	≤200Hz peak(at ≤250kHz+7dBm internal 1kHz30%)
Fre- quency modu- lation	Range	0 to 400kHz(1MHz ≤fc<40MHz) 0 to 100kHz(40MHz ≤fc<80MHz) 0 to 200kHz(80MHz ≤fc<160MHz) 0 to 400kHz(160MHz ≤fc<320MHz) 0 to 800kHz(320MHz ≤fc<640MHz) 0 to 1.6,MHz(640MHz ≤fc<1280MHz) 0 to 3.2MHz(1280MHz≤fc)
	Resolution	10Hz (0 to 9.99 kHz deviation) 100Hz (10 to 99.9kHz deviation) 1kHz (100 to 666 kHz deviation) 10kHz (1 to 3.2 MHz deviation)
	Internal modulation frequency	Fixed freqeuncy:400Hz ,1kHz Variable frequency:0.1 to 100kHz 0.1Hz resolution Frequency accuracy:100ppm
	Accuracy	±(5% of indicated valeu+20Hz)[internal 1kHz)
	Modulation frequency response	±1dB bandwidth Frequency range :20Hz to 100kHz(EXT AC mode )DC to 100kHz (EXT DC mode)
	External modulation	Input level :Approx.2 Vp-p/600Ω Input impedance:Nominal 600Ω
	Distortion	≤1%(internal 1kHz 3.5kHz deviation)
	Incidental AM	≤4%(internal 1kHz 22.5 kHz deviation,demodulationband 0.3 to 3kHz)
	Carrier frequency accuracy in DC-FM mode	±500Hz for 30-minute period after calibrationand 2-hour warm-up(at <1280MHz,<10kHz deviation)
Phase modul- ation	Range	0 to 80 rad (1MHz ≤fc<40MHz) 0 to 20 rad (40MHz ≤fc<80MHz) 0 to 40 rad (80MHz ≤fc<160MHz) 0 to 80 rad (160MHz ≤fc<320MHz) 0 to 160 rad (320MHz ≤fc<640MHz) 0 to 320 rad (640MHz ≤fc<1280MHz) 0 to 640 rad (1280MHz ≤fc) Besiees radian,deg unit is also possible for phase deviation display.However,mzs.999deg
	Resolutin	0.01 rad (0 to 9.99 rad deviation) 0.1 rad (10 to 99.9 rad deviation) 1 rad (100 to 640 rad deviation)
	Internal modulatio frequency	Fixed freqeuncy:400Hz ,1kHz Variable frequency:0.1 Hz to 5kHz 0.1 resolution Frequency accuracy:100ppm
	Accuracy	±(10% of indicated valeu+20Hz)[internal1kHz modulation]
	Modulation frequency response	±1dB bandwidth Frequency range :20Hz to 5kHz(EXT AC mode )DC to 5kHz (EXT DC mode)
	Externulation	Input lievel:Approx.2 Vp-p/600Ω Input impedane:Nominal 600Ω
	Distortion	≤(internal 1 kHz 5 rad modulation)
Intemal modul- ation signal	Frequency range	400 Hz ,1kHz,(fixed oscillator) 0.1Hz to 100kHz (variable oscillatior) DC voltage signals equivalent peak values of internal modulationg sine wavecan be applied as a modulationg singnal using the SPECLAL FUNCTION.
	Resolution	0.1Hz
	Frequency accuracy	100ppm
	Distion	≤0.03%(fixed,400Hz and 1kHz)≤0.3%(variable20Hz to 50kHz)
Memory function	Frequency memory	1000 carrier frequencies(store /recall)
	Funcition memory	100 panel settings(store/recal)
	Sweep mode	Carrier freqeuncy ,output level,AF frequency
Sweep tunc- tion	Sweep time	0.1 ms to 600s ,0.01ms resolution(minimumtime depends on the switching time of each function.)
Other func- tions	Marker	One movable marker
	Sweep signal output	Staircase (saw-tooth waeform ),Start point:0V,Stop point:100V)
	Modulation signal output	Modulation signal is outputwhen modulationg Output level:Approx.2 Vp-p/600Ω
	Relative value display	Carrier frequency,output level
	Continuouly variable output level mode	Continuousltyvariable within a±10dB rqngeof the set level Step size:0.1dB
	Trigger function	Previously programmed operation procedurecan be started by a trigger input through its input termibal(on reqr panel,BNCconnector,TTL level)Maximum program steps for triggereed operation:99 steps
	Memory backup	Last settings are stored when pwer is turnedoff
	GPIB	Interfacce function:SH1,AH1,T5,L3,TE0,RL1,PP0,DC1,DT1,CO
Reverse power		Maxium reverse input power:50W (<100MHz)25W(≥1000MHz)±DC50V
Operating- temperatur		0 °to 50℃
Power		*7Vac+10 -15%48 to 63 Hz ≤270VA
Dimensions- and mass		426(W)*177(H)*451(D)mm≤32kg
EMC*^8		EN55011:1991,Group 1, Class A EN50882-1:1992
Safety		EN61010-1:1993(Instalation Category II PollutionDegree II)

仪器保证：

我们的大多数设备在装运之前均经过严格的质量检测与校验。也可申请国家计量证书。